H.S. Lakshmi Engineering

Supplying and Applying 1st coat of waterproofing coating in single coats @500GMS/M2/COAT and supplying and applying 2 coat of two Component Acrylic Cementetious Waterproofing Coating in single coats @750GMS/M2/Coat.

Surface Providing and Applying methods clean and wash the floor, cut open the gaps and the joint upto 2mm depy Apply MYK Laticrete tile grouting powder and Sika Raintite tille joint to all joints and to be treated
Brush apply 1 primer coat of   Primer with dilute ratio 1:2 and allow to dry for 4hrs, Brush apply 2 coat of   Surface to complete functional usage ADVANTAGE: - Crack bridging capability, Water vapour permeable, UV , algae, & Fungus resista

Asian Paints SmartCare Waterproofing MembraneAPP Modified Glass Fiber Sheet Reinforced Bituminous Membrane ( 3 mm):- Apply bitumen based primer as per recommended coverage and allow it to dry till tack free (about 6-8 hours)
Asian Paints SmartCare Damp Proof is a fiber reinforced elastomeric liquid applied water proofing membrane. It is formulated with select elastomeric and resilient acrylic polymers and reinforcing polyester fibers. Upon curing, it formsa thick, seamless, durable membrane thus offering ultimate waterproofin Supplying apply 1 primer coat of Asian Damp Proof Primer with dilute ratio 1:2 and allow to dry for 4hrs, Brush apply 2 coat of Asian Damp Proof Surface to complete functional usage ADVANTAGE: - Crack bridging capability,

Cementations Pressure Grouting:- Drilling hole of 14mm dia to a depth of average 100mm on tank floor area and wall surface fixing nozzles of size dia and length of 75mm of which 50mm shall be fixed in underneath using Renderoc plug Chemicals, & 25mm extended out, Grouting of cement mixed with additives, Cebex-100 at 225 gms/bag cement & Nitobond SBR at 0.5% per bag of cement in to the already provided nozzles with pressure not exceeding 2Kg/Cm2 till the nozzles Refuse to take further grout & removal of nozzles & making good the surface etc. Comple

Providing and applying methods,acid clean and wash the floor area Cut open the gaps and tile joint upto 2mm dept, Apply  epoxy tile joint to all the joints and to be treated        

SURFACE PREPARATION • The surface should be free from grease, oil dead mortar / concrete etc. • Remove all loose concrete/dead mortar with gentle chipping to roughen the surface. • Clean the surface with wire brush                                                                             

                                                                                                                                                                                                                                                                                       polymer waterproofing services Sbr waterproofing services